 | Wetroom Supplies and Solutions
The Only One-Stop Wetroom Wholesaler
|
Wetroom Kits
|
|
|
|
Next Day Delivery (excluding screens) |
KITS FROM £320 WITHOUT SHOWER SCREEN
WETROOM - IN - A - BOX
Our entry level product, still a best seller
£320 - £494 incl carriage
All you need to make a sealed wet room. A simple DIY solution for ready - to - tile floor & walls, instructions supplied.
The most complete kit available, See contents below.
Needs boarding between or over joists.
Shapes : Rectangles, Square, Circles or Ovals
Thin Base: 20 mm, 24mm, 27mm fits flush with floorboards, ie level access, no step.
Trimmable edges: 160mm ( or more with care )
Drain: Central or Offset, Horizontal, or Vertical pipe outlet.
Floor Type: Concrete or timber joists, all types no limit.
Tanking Kit: Seals the wet area including joints & corners.
Contents: Showerlay ( floor former) , drain, stainless steel grid, pipe reducer, 8k Lastogum tanking, 10 mt tape, 2 internal corners, 2 pipe collars, 1 litre primer, Brush. Shower screen (optional extra). Instructions.
Tools needed: Spirit level 900 - 1200 long, 3inch brush, craft knife, handsaw or circular saw ( to cut floorboard), screwdriver, 2 & 3 inch screws, hammer, 4 inch nails, silicone or flexible tile adhesive .
These are some of our kits. Many other permutations are possible with a little imagination, incorporating hinged doors or fixed screens, or both. A level access floor will be achieved providing there is room for the drain (83mm deep).The floor will have no step (but see FAQ's).
|
 |
1 - Showerlay Underlay for level access
1 - Dallmer drain c/w stainless grid. Horizontal or vertical outlet (please specify)
1 - Pipe reducer 2" to 1½"
1 - 8k tanking liquid, Lastogum (covers 5 - 7m²)
1 - 1 litre Primer for porous surfaces
1 - 10m Flex Tape for wall/floor joint and other gaps
2 - Flex internal corners
2 - Flex pipe collars
* - Centr or Offset available. Makes a total of 12
|
 |
 |
 |
 |
 |
|
 |
1 - Showerlay wet-floor former (Underlay base)
1 - Dallmer drain c/w stainless grid. Horizontal or vertical outlet (please specify)
1 - Pipe reducer 2" to 1½"
1 - 8k tanking liquid, Lastogum (covers 5 - 7m²)
1 - Primer for porous surfaces. 1 litre, can dilute with water
1 - 10m Flex Tape for wall/floor joint and other gaps
2 - Flex internal corners
2 - Flex pipe collars
1 - 6mm x 2000 high clear screen (fixed panel). The width is specified but many options are available on request
Hardware included - 8mm or 10mm thick screens at extra cost
1 - Set of seals (not always used in wetrooms)
|
 |
 |
 |
 |
|
| Extra sizes on request: | 800 x 800 centre drain £676 1200 x 900 centre drain £743 1200 x 900 offset drain £743 |
Offshore carriage surcharge £45 |

Cross-section Maxxus with Tiling finish |

Cross-section Maxxus with Vinyl finish |
DESIGNER GRIDS

Designer Grids - 316 grade stainless steel polished finish will not harbour grime and algae unlike brushed finish.
Compatible with Showerlay and Maxxus
*Special Offer £37 each*
|
PUMPED SOLUTION DRY-DECK 20
See FAQs for technical information

MEMBRANE OPTIONS
BSA SHEET MEMBRANE KIT
Bitumen self adhesive sheet membrane
10 mt.sq kit £234
5 mt.sq kit £154
Contents:
Roll of membrane 1000 wide
15 mt Joint Tape
1 Litre Primer
1 Cartridge Joint Sealant
1 Roller
Instructions
|
 |
LASTOGUM TANKING KIT: £79
8k Lastogum
10mt.Flex Tape
2 Flex Internal Corner
2 Pipe Collars
1 Brush
1 Litre Primer
ENHANCED KIT: Above comes with Flex Mat to seal monobloc drain into a sloping concrete floor (see product page)
|
 |
|